Installing The Input/Output Panel; Removing The System Board - Dell OptiPlex 9010 Owner's Manual

7. Slide the I/O panel towards the left of the computer to release it and pull the I/O panel along with its cable out of the
computer.

Installing The Input/Output Panel

1. Insert the Input/Output Board into the slot on the chassis front.
2. Slide the Input/Output Board towards the right of the computer to secure to the chassis.
3. Tighten the screw securing the Input/Output Board to the chassis.
4. Thread the Input/Output Board/FlyWire cable into the chassis clip.
5. Connect the Input/Output Board/FlyWire cable to the system board.
6. Install the optical drive.
7. Install the disk drive.
8. Install the front bezel.
9. Install the cover.
10. Follow the procedures in

Removing The System Board

1. Follow the procedures in
2. Remove the
a) cover
b) front bezel
c) expansion card
d) memory
e) heat sink
f) processor
3. Disconnect all the cables connected to the system board.
After Working Inside Your Computer .
Before Working Inside Your Computer .
35