Configuring The Gtp Of The Iwag - Cisco Intelligent Wireless Access Gateway Configuration Manual

Configuring the iWAG for 3G Mobile IP Users
Enabling MCSA is mandatory before you enable the Mobility feature in the Cisco ASR 1000 Series
Note
Aggregation Services Routers.
SUMMARY STEPS
1. enable
2. configure terminal
3. mcsa
4. enable sessionmgr
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3
mcsa
Example:
Router(config)# mcsa
Step 4 enable sessionmgr
Example:
Router(config-mcsa)# enable sessionmgr

Configuring the GTP of the iWAG

This section describes how to configure GTPv1 for the iWAG solution.
Before You Begin
Enable mobile client service abstraction (MCSA).
Intelligent Wireless Access Gateway Configuration Guide
18
Overview of the Intelligent Wireless Access Gateway
Purpose
Enables the privileged EXEC mode.
Enter your password, if prompted.
Enters the global configuration mode.
Enables MCSA on the Cisco ASR 1000 Series Aggregation
Services Router.
Enables MCSA to receive notifications from the Cisco ISG.
OL-30226-03