Assembly - ProForm 831.28543.0 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver
wrench , and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST on page 21. The second number is the
quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the
parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free 1-888-533-1333.
M8 Split
M10 Split
Washer (70)–2
Washer (100)–4
M4 x 16mm M8 x 25mm Patch
Screw (66)–4 Screw (22)–2
M4 x 19mm
Screw (74)–2
Wave Washer
(95)–2
M8 x 45mm Button
Bolt (50)–4
M8 x 65mm Button
Screw (99)–4
M10 x 112mm Carriage Bolt (34)–4
M10 x 88mm Button Screw (63)–2
.
M8 Large
Washer (53)–10 Locknut (46)–8
M10 x 52mm Bolt Set (27)–2
5
, an adjustable
M8 Nylon M10 Nylon
Locknut (29)–4
M8 x 50mm Button
Screw (89)–4