Table of Contents
Advertisement
Amplifi er assembly replacement continued:
6
Five cables need to be removed from
the amplifi er assembly: (1) solid yellow,
(2) yellow and black, (3) solid blue, and
(4) blue and black. The fi fth cable (led
PCB cable) is shown in step 7 below. Do
not force cable removal or connection,
although needle-nose pliers may aid in
loosening the crimped cables.
7
The led PCB cable is shown above. The
black wire of the cable is closest to the
edge of the amplifi er assembly. The
cable only fi ts in one way.
1
2
3
4
8
Place the new amplifi er assembly
(part #0014137-00) where the old one
was. Follow the same steps as above,
but backwards 7 to 1. Remove the
serial number from the faulty amplifi er
assembly (as shown in picture above)
and place on the new amplifi er
assembly. Power up the SR1521z and
relish in the fact that you just replaced
an amplifi er assembly. Hats off to you for
a job well done!
9
Important:
The faulty amplifi er
assembly must be returned to LOUD
Technologies. The address should
be on the return shipping label that
was provided with the new amplifi er
assembly. If not, the return address is at
the top of this page. Also, please write
the order number and service request
number (ex: 1046256-1203935) in big,
black, bold numbers on the outside of
the box. This helps expedite the return.
14
Advertisement
Table of Contents
