Porter-Cable 345 Instruction Manual page 8

SYMBOL
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
F ........................ farads
µF ........................ microfarads
l ........................ litres
g ........................ grams
kg ........................ kilograms
bar ........................ bars
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
n ........................ no-load speed
0
.../min or ...min -
or d.c. ................ direct current
or a.c. ................ alternating current
2
........................ two-phase alternating current
2
N ........................ two-phase alternating current with neutral
3
........................ three-phase alternating current
3
N ........................ three-phase alternating current with neutral
........................ rated current of the appropriate fuse-link in amperes
........................ time-lag miniature fuse-link where X is the symbol
........................ protective earth
........................ class II tool
IPXX
........................
MOTOR
Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60
cycle A.C. current and voltage within plus or minus 5 percent of that shown on
the specification plate on the tool. Several models, however, are designed for
A.C. current only. Refer to the specification plate on your tool for proper voltage
and current rating.
voltage is not within correct limits. Do not operate tools rated A.C.
only on D.C. current. To do so may seriously damage the tool.
DEFINITION
1 ......... Revolutions or reciprocations per minute
for the time/current characteristic, as given in IEC 60127
IP
symbol
Do not operate your tool on a current on which the
8