Table of Contents
Advertisement
INSTALLATION AND CARE OF DUST BAG
NOTE: An adapter and hose are available as accessories for connecting
the exhaust opening directly to a shop-type vacuum cleaner.
A dust bag is available as an accessory. To install the dust bag:
Disconnect tool from power source!
1.
Open the exhaust cover (A) Fig.
13, and clean out any accu-
mulated sawdust.
2.
Insert the dust bag tube in
exhaust opening and push in
until seated.
3.
To remove, grasp the dust bag
tube where it enters the exhaust
opening and pull out.
4.
Unzip the bag and shake out
the sawdust. Occasionally turn
the bag inside out and brush
thoroughly.
To avoid personal injury from flying sawdust, keep the
exhaust cover closed when the nozzle is not installed. NEVER insert foreign
objects into exhaust opening.
TO ATTACH THE RIP GUIDE
A rip guide (Fig. 14) is available as an accessory. To install:
Disconnect tool from power source!
1. Insert the rip guide through the
slot in the left side of the base,
over the stud, and through the slot
in the right side of the base.
2. Install the knob and washer on the
stud, and adjust the rip guide for
the desired width of cut, taking
into consideration the set of the
blade teeth.
3. Tighten the knob securely.
To avoid damage to the workpiece and possible personal
injury, extend the rip guide through both slots in base.
Fig. 13
Fig. 14
15
A
Hide quick links:
Advertisement
Table of Contents
