Discharge Pipe Temperature Control - Daikin CTXS09GVJU Service Manual

SiUS12-814

5.16 Discharge Pipe Temperature Control

F3
Remote
Controller
Display
Outdoor Unit LED A 5
Display
Method of
The discharge pipe temperature control (stop, frequency dropping, etc.) is checked with the
Malfunction temperature being detected by the discharge pipe thermistor.
Detection
Malfunction 2YC45, 2YC63
Decision If the temperature being detected by the discharge pipe thermistor rises above 120°C, the
compressor will stop. (The error is cleared when the temperature has dropped below 107°C.)
Conditions
Supposed
Causes
Troubleshooting
Check No.04
Refer to P.159
Check No.06
Refer to P.161
Check No.11
Refer to P.164
Service Diagnosis
1 4 2 1 3 4 4 1
If the compressor stops 6 times straight due to abnormal discharge pipe temperature, the
system will shut down.
The error counter will reset itself if this or any other error does not occur during the following 60-
minute compressor running time (total time).
Refrigerant shortage
Four-way valve malfunctioning
Discharge pipe thermistor defective
(heat exchanger or outdoor temperature thermistor defective)
Outdoor unit PCB defective
Water mixed in the local piping
Electronic expansion valve defective
Stop valve defective
Be sure to turn off power switch before connect or disconnect connector,
Caution or parts damage may be occurred.
Check No. 06
Check the thermistors.
Functioning
Check No. 04
Check the electronic
expansion valve.
Functioning
Check No. 11
Check the refrigerant
line.
Functioning
Malfunctioning
Discharge pipe thermistor
Outdoor unit heat exchanger thermistor
Outdoor temperature thermistor
Malfunctioning
Malfunctioning
Refrigerant shortage
Four way valve malfunctioning
Water mixed
Stop valve defective
Troubleshooting
Replace the defective
thermistor.
Replace the valve itself or
the coil.
Refer to the refrigerant line
check procedure.
Replace the outdoor unit
PCB.
(R7141)
135