Intermec PC23 User Manual page 81

PC23 and PC43 Desktop Printer User Manual
Setting Description
Clip Default Determines if the printer prints
items outside the printable area of
the label.
When this is set to Off, the printer
returns an error if any part of a bar
code label cannot be printed
because that part extends beyond
the printable area. When this is set
to On, the printer prints all bar
code labels, but may also print
unreadable, incomplete labels.
Start Adjust Sets the length of media the
printer feeds (positive value) or
retracts (negative value) before
printing a label. Unit of
measurement is defined in the
Unit of Measure parameter. Range
is -9999 to +9999.
Stop Adjust Sets the length of media the
printer feeds (positive value) or
retracts (negative value) after
printing a label. Unit of
measurement is defined in the
Unit of Measure parameter. Range
is -9999 to +9999.
Media Calibration Selects the mode the printer uses
Mode to calibrate media. Use Slow if the
printer has trouble identifying
gaps or marks in media.
Length (Slow If Media Calibration Mode is set
Mode) to Slow, the printer prints the
media length plus 10 mm. This
value sets an additional amount
of media to be printed. Unit of
measurement is defined in the
Unit of Measurement parameter.
Range is 0 to 3200.
LTS Sensitivity Sets the sensitivity of the label
Level taken sensor. Range is 0 to 14.
Supported when the Cutter or
Label Dispenser accessories are
installed.
Chapter 2 — Set Up the Printer
Default
Off
0
0
Fast
0
0
67