Security - Draytek Vigor2110 Series User Manual

Packet-OVERDRIVE
Rate Control
4 . 1 3 . 3 S e c u r i
4 . 1 3 . 3 S e c u r i
This page allows you to set security with different modes for SSID 1, 2, 3 and 4 respectively.
After configuring the correct settings, please click OK to save and invoke it.
By clicking the Security Settings, a new web page will appear so that you could configure the
settings of WEP and WPA.
Vigor2110 Series User's Guide
t y
t y
This feature can enhance the performance in data
transmission about 40%* more (by checking Tx Burst). It
is active only when both sides of Access Point and Station
(in wireless client) invoke this function at the same time.
That is, the wireless client must support this feature and
invoke the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the
following picture of Vigor N61 wireless utility window,
choose Enable for TxBURST on the tab of Option).
It controls the data transmission rate through wireless
connection.
Upload – Check Enable and type the transmitting rate for
data upload. Default value is 30,000 kbps.
Download – Type the transmitting rate for data download.
Default value is 30,000 kbps.
201