More
RIP Direction
From first subnet to
remote network, you
have to do
Change default route to
this VPN tunnel
phase 2 quick mode.
Add a static route to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction here.
Herein, we provide four options: TX/RX Both, TX Only, RX
Only, and Disable.
If the remote network only allows you to dial in with single
IP, please choose NAT, otherwise choose Route.
Check this box to change the default route with this VPN
tunnel.
172
Vigor2110 Series User's Guide