Electrical Data - Heat Controller HEV Series Installation, Operation & Maintenance Manual

Installation, Operation & Maintenance
WARNING!
WARNING! To avoid possible injury or death
due to electrical shock, open the power
supply disconnect switch and secure it in an
open position during installation.
CAUTION!
CAUTION! Use only copper conductors for field
installed electrical wiring. Unit terminals are not
designed to accept other types of conductors.

Electrical Data -

HE Volt
Rated Voltage
Model Code
024 1 208-230/60/1
030 1 208-230/60/1
036 1 208-230/60/1
042 1 208-230/60/1
048 1 208-230/60/1
060 1 208-230/60/1
HACR circuit break in U.S. only
All fuses Class RK-5
HEV/H SERIES
ELECTRICAL - LINE VOLTAGE
Compressor
Voltage
Model
Min/Max
RLA LRA
197/254 024 11.7 58.3
197/254 030 14.7 73.0
197/254 036 18.0 83.0
197/254 042 21.8 96.0
197/254 048 25.0 104.0
197/254 060 28.9 152.9
Wire length based on one way measurement with 2% voltage drop
Wire sizes based on 140°F (60°C) copper conductor
Electrical - Line Voltage
All field installed wiring, including electrical ground, must
comply with the National Electrical Code as well as all
applicable local codes. Refer to the unit electrical data for
fuse sizes. Consult wiring diagram for field connections
that must be made by the installing (or electrical)
contractor.
All final electrical connections must be made with a
length of flexible conduit to minimize vibration and sound
transmission to the building.
General Line Voltage Wiring
Be sure the available power is the same voltage and
phase shown on the unit serial plate. Line and low voltage
wiring must be done in accordance with local codes or the
National Electric Code, whichever is applicable.
Int
HWG Fan
Loop
Pump Motor
Pump
FLA FLA
Qty
FLA
1 0.4 1.7 3.9
1 0.4 1.7 3.9
1 0.4 1.7 3.9
1 0.4 1.7 5.2
1 0.4 1.7 5.2
1 0.4 1.7 6.9
22
Heat Controller, Inc.
Total Min Max
Unit Circuit Fuse/ Fuse/
FLA Amps HACR HACR
17.7 20.6 32.3
20.7 24.3 39.0
23.9 28.4 46.3
29.1 34.5 56.3
32.2 38.5 63.5
37.9 45.1 74.0
Max
30
35
45
50
60
70