Cub Cadet Domestic Series 7000 Service Manual page 66

Domestic Compact Dash and Steering Pump
1.20. Carefully lift the dash panel and remove it from
the tractor. Confirm that the wiring harness and
control cables do not snag as they pull out with
the dash panel. See Figure 1.20.
2 Back
1 Up
Figure 1.20
1.21. Dash panel installation is essenitally the the
reverse of the removal process. The following
tips may ease the installation:
1.22. Route the control cables as the dash panel is
lowered into place. The throttle cable passes
through the grommeted hole at the top right cor-
ner of the lower heat shield. See Figure 1.22.
Throttle cable
Figure 1.22
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
1.23. The choke cable on gasoline engined tractors
1.24. The choke cable then passes through the grom-
Throttle cable
Choke cable
1.25. Lower the dash panel into positon, so that the
1.26. Confirm that the lower rear cornerof the dash
1.27. Confirm that the lower right mounting point has
62
passes through the large opening in the pedes-
tal, below and to the left of the steering column
bracket. See Figure 1.23.
Choke cable
Figure 1.23
meted hole at the lower right corner of the lower
heat shield. See Figure 1.24.
Figure 1.24
slotted holes flanking the instrument panel slip
over the bolts between the heavy flat washers
and the pedestal.
panel has cleared the brake pedal.
cleared the fuse and relay center.