Cub Cadet Domestic Series 7000 Service Manual page 56

Domestic Series 7000 MFD
9.42. The final assembly is easiest to perform with the
axle housing in a vertical position.
See Figure 9.42.
Figure 9.42
NOTE: Any number of means can be improvised
to suspend the axle housing by the pivot journal,
with the drop axle housing on the ground for sta-
bility.
9.43. Install the washers originally removed from
between the right differential bearing and the
right inner axle bearing. See Figure 9.43.
Shim washers
Figure 9.43
NOTE: If no major components have been
replaced, this is likely to result in the correct ring
and pinion gear back-lash setting. Otherwise,
some adjustment may be necessary.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
9.44. Place the differential assembly into the right side
•
•
9.45. Install the left side differential bearing wrong-
Differential set-up
plate tool
Left side
differential bearing
52
axle housing. See Figure 9.44.
Roll pin
14 tooth
miter gear
Figure 9.44
The 14 tooth miter gear in the differential must
seat over the splined end of the axle shaft.
The roll pin in the differential cross pin must seat
into the bore in the end of the axle shaft.
way-around in the differential housing: the nar-
row margin of the outer bearing race should be
seated in the differential, with the wide margin
facing up. See Figure 9.45.
Figure 9.45
Cross
shaft
Right
side
axle