Sensor Module; Description Files For Fieldbuses - Siemens ZTH Getting Started

Installing

3.4 Description files for fieldbuses

3.3.2

Sensor Module

Table 3- 2
Two-pole resolver
Multi-pole resolver
sin/cos encoder 1 V
sin/cos encoder 1 V
(C and D tracks)
SSI encoders with incremental signals sin/cos 1
V
pp
SSI encoders with TTL/HTL incremental signals
SSI encoder without incremental signals
HTL or TTL encoder
Absolute encoders Endat 2.1
Information about installing and connecting the Sensor Modules is provided in the
"SINAMICS S120 Control Units and additional system components" manual, also see
Section: Manuals for your inverter (Page 43).
3.4 Description files for fieldbuses
The description files contain the information required to configure and operate the converter
on a fieldbus under a higher-level control.
Description file Download
GSD for PROFIBUS Internet:
(http://support.automat
ion.siemens.com/WW/
view/en/23450835)
GSDML for Internet:
PROFINET (http://support.automat
ion.siemens.com/WW/
view/en/26641490)
EDS for CANopen Internet:
(http://support.automat
ion.siemens.com/WW/
view/en/48351511)
EDS for Ethernet/IP ---
32
Permissible SMC/SME Sensor Modules and encoders that can be connected
pp
without rotor position track
pp
Alternative to download
GSD and GSDML are saved in the converter. The converter writes its GSD
or GSDML to the memory card once you insert this card in the converter
and set p0804 to 12. You can then transfer the file to your programming
device or PC using the memory card.
---
Further information can be found in the operating instructions
SMC10 SMC20 SMC30
✓
✓
✓
✓
✓
✓
✓
✓
Converters with CU250S-2 Control Units
Getting Started, 10/2013, FW V4.6, A5E32899990B AA
SME20 SME25
✓
✓
✓