Siemens ZTH Getting Started page 35

5. In STARTER, press the
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
7. Select the inverter ☑.
8. Press the "Accept" button.
You have transferred an inverter accessible via the USB interface into your project.
Setting the USB interface
Procedure
Proceed as follows to set the USB interface in STARTER:
1. In this case set the "Access point" to "DEVICE (STARTER, Scout)" and the "PG/PC
2. Press the "Update" button.
You have set the USB interface.
STARTER now shows the inverters connected via USB.
Converters with CU250S-2 Control Units
Getting Started, 10/2013, FW V4.6, A5E32899990B AA
shows the inverters that can be accessed.
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
interface" to "S7USB".
("Accessible nodes") button.
Commissioning
4.2 Commissioning with STARTER
35