Removal Of Lcd Block - Sony DCR-TRV5 Service Manual

2-7. REMOVAL OF LCD BLOCK

2 Press the claw
3 Pull
1 Cushion
Remove the flexible board
connected to the LCD,
from the cabinet (R) assembly
!§ Remove the LCD cabinet (R) assembly
in the direction of the arrow while taking
care not to damage the harness (SP-154)
Speaker
Cushion (VL)
!∞ Claws
Harness
@£ LCD901
LCD lock spring
Open button
@¡ Claws
@™ LCD cabinet (L)
Control switch block (VL4680)
5 FP-699 flexible board
PANEL CLOSE switch (S002) block
#∞ Insert a tweezers tip
or the like and snap
it out
!ª From CN5804
!ª From CN5501
#™ PD-100 board
#¡ LCD frame
@¢ ND901
#º Claws
@º M1.7
2.5
Sleeve harness
(3-051-046-01)
@• Hinge assembly * 1
Attach sleeve harness to
hinge assembly by
adhesive agent.
6 M2
2.5
4 M1.7
2
6 M2
2.5
#£ 2
5
#¢ Lithium battery
lid
#§ Harness SP-155
8 Turn the LCD block in
the direction of the arrow
#¶ LI-65 board
!¡ Hinge cover (rear)
9 M1.7
2
7 Turn the tilt base
!ª From CN5701
@ª M1.7
2
!• PD flexible
sheet
P D
- 1 0
B o
0
a r
d
!¶ Harness SP-154
(from CN5803)
a
Hinge assembly
(X-3948-660-1)
* 1 When replacing the hinge assembly, replace the hinge cover (lower)
and sleeve harness at the same time because the hinge assembly
does not include the hinge cover (lower) and sleeve harness.
2-5
9 M1.7
2
!¡ Hinge cover (front)
!º Claws
!™ M1.7
in the direction
of the arrow
!£ FP-699 flexible board
Speaker
!§ LCD cabinet (R)
assembly
!¢ M1.7
a
@∞ Harness blind tape
@¶ M1.7
2
@§ Harness SP-152
(from CN5802)
@§ Harness SP-153
(from CN5801)
Hinge cover (lower)
(3-989-856-01)
Melt them by soldering iron or
attach them with adhesive agent
2
2