Clock Adjustments; Ic1900 27Mhz Xtal F; (Vc-207 Board); Ic1900 Vco Operation Check (Vc-207 Board) - Sony DCR-TRV5 Service Manual

3-5-2.

Clock Adjustments

1. IC1900 27MHz XTAL f

0
Set the sub-carrier frequency of the video output signal in the VTR
mode.
Mode VTR stop
Signal No signal
R1901 (Pin 2 of IC1900) or Pin 8
Measurement Point
of IC 1104
Measuring Instrument Frequency counter
Adjustment Page D
Adjustment Address 98
Specified Value R1901:
f = 13500000 ± 68 Hz
Pin 8 of IC1104:
f = 6750000 ± 34 Hz
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 98, change the data and set the clock
frequency (f) to the specified value.
3) Press the PAUSE button of the adjustment remote commander.
4) Select page: 0, address: 01, and set data: 00.

2. IC1900 VCO Operation Check (VC-207 Board)

Mode VTR stop
Signal No signal
Measurement Point Display data of page: 2, address: 0E
Measuring Instrument Adjustment remote commander
Specified Value "C0" to "FF"
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 2, address: 05, set data: 02, and press the PAUSE
button of the adjustment remote commander.
3) Select page: D, address: B0, set data: 03, and press the PAUSE
button.
4) Select page: 2, address: 0E, and check that the data is "C0" to
"FF".
5) Select page: D, address: B0, set data: 05, and press the PAUSE
button.
6) Select page: 2, address: 0E, and check that the data is "C0" to
"FF".
7) Select page: D, address: B0, set data: 00, and press the PAUSE
button.
8) Select page: 2, address: 05, set data: 00, and press the PAUSE
button.
9) Select page: 0, address: 01, and set data: 00.
Adjustment (VC-207 Board) 3. IC6101 41.85MHz VCO Operation Check

(VC-207 Board)

Mode
Subject
Measurement Point
Measuring Instrument
Specified Value
Checking method:
1) Select page: 3, address: 39, and check that the data is "37" to
"C9".
5-43
Camera recording
Arbitrary
Display data of page: 3, address: 39
Adjustment remote commander
"37" to "C9"