Installation / Assembly - Jenn-Air 38” Use And Care Manual

INSTALLATION / ASSEMBLY

Note: Prior to assembly remove protective film from stainless steel parts
Cart Assembly
1. Attach the two L-shaped sides to the U-
shaped back portion of the cart, making sure
the four holes face up & the key holes are on
the bottom, using the (8) self taping hex
head screws. (See Fig. 1)
Note: A power screwdriver is required to
install the screws-be cautious not to over-
tighten and strip the screws.
2. Set the base on the top of the cart assembly,
with large opening closer to back portion of
cart, and align the eight mounting holes. Then
set the 2 wheel channels on the base and
attach them using the (8) bolts provided, from
inside the cart upwards through wheel
channels. (See Fig. 2)
Note: Tighten the bolts securely & Set Cart Upright
Attaching Grill Head to Cart w/door
Use the following instructions to attach Grill to cart
with a door.
1. With the grill on its back, loosen all 4 bolts
on the bottom side of the grill. (See Fig. 3)
2. Using 2 self taping hex head screws,
attach the magnetic door catch in the 2 holes
in the bottom of the grill. (See Fig. 4)
5
Screws
Key Holes
Screw holes for
magnetic catch
Bolts
Catch faces
towards front
of grill
Screws under
edge of bracket
Fig. 1
Fig. 2
Fig. 3
Fig. 4