Hitachi CP-S830W/E Operating Manual page 24

Connection to the control signal terminal (continued)
Item
MOUSE
COMMUNICATE
POWER
MIRROR
INPUT
VIDEO
SYSTEM
VOLUME
MUTE
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
H. PHASE
H. POSIT
H. SIZE
V. POSIT
BLANK
REVEAL
Caution If computer sends the undefined command code or data code, Projector can not guarantee operation.
Command is consisted of 2 command bytes and following data bytes.
1-st byte indicates the kinds of commands and the length of command.
'0xH' : Error-reply
'1xH' : Command reply
'2xH' : Ask command
'3xH' : Set command
'4xH' : Default set command
'5xH' - 'FxH' : Reserved
'x' indicates the length of data bytes.
2-nd byte indicates the command code 'yy' as command table.
Data table shows the data byte.
24
Control data table
00h=stop mouse emulation. 01~7Fh=start mouse emulation
0Xh=8N1
1Xh=7N1
X0h=1200bps, X1h=2400bps, X2h=4800bps, X3h=9600bps, X4h=19200bps
1Eh=Power off (Standby mode), 1Fh=Power on
00h=Normal, 01h=H:Invert, 02h=V:Invert, 03h=H&V:Invert
11h=VIDEO1, 12h=VIDEO2, 21h=RGB1, 22h=RGB2
00h 00h=Auto, 00h 01h=NTSC, 00h 04h=NTSC4.43
00h 02h=PAL, 00h 03h=SECAM, 00h 05h=M-PAL
00h (min) ~ 24h (max)
00h=Mute off, 01h=Mute on
00h 00h 00h (dark) ~ 00h 00h 24h (brite)
00h 00h 00h (lower) ~ 00h 00h 24h (higher)
00h 00h 00h (less) ~ 00h 00h 24h (more)
00h 00h 00h (red) ~ 00h 00h 24h (green)
00h 00h 00h (soft) ~ 00h 00h 24h (sharp)
00h 00h 00h ~ 00h 00h 1Fh
00h 00h 00h 00h (left) ~ 00h 00h 37h 04h (right)
00h 00h 78h 05h (narrow) ~ 00h 00h 30h 0Eh (wide)
00h 00h 01h 00h (down) ~ 00h 00h 58h 04h (up)
0Xh=Blank off
1Xh=Blank on
bit0 0=Blue off, 1=Blue on, bit1 0=Green off, 1=Green on
bit2 0=Red off, 1=Red on, bit3 0=Not change, 1=change
X1h=Reveal down, X4h=Reveal right, X=0 (slow) ~ 7 (fast)
Projector sends to computer.
Projector sends to computer.
Computer sends to Projector.
Computer sends to Projector.
Computer sends to Projector
Data code