Installation - Hitachi CP-S830W/E Operating Manual

Installation

Example of the projector and screen installation
Determine picture size and projection distance as illustrated below.
View from the top
Screen
Screen (inch)
Minimum
40
60
80
100
120
150
200
How to use foot adjusters
Adjust the projection position using the foot adjusters at the bottom of the projector.
View from the front
Foot adjuster
1. Lift up the projector and press the button of the adjuster to release the lock.
2. Adjust the projection angle, release the button of the adjuster and securely lock it.
3. To adjust the angle slightly, revolve the foot adjusters.
· Do not unlock the foot adjusters while you do not support the projector, to avoid falling of
Caution
the projector and causing an injury.
· Do not revolve the foot adjusters by force, the foot adjusters is damaged.
· Securely lock the adjuster.
· Do not apply unnecessary force from the upper side when lifting the projector. Otherwise,
projector may be damaged or a finger could be caught and cause injury.
a:Distance from the projector to the screen.
(tolerance :
a (inch)
This screen size is full-screen size.(800 dots X 600 dots)
Maximum
67 87
98 130
130 173
165 217
197 260
248 327
331
View from the side
Lens center
a
10%)
Installation of liquid crystal projector
Please basically use liquid crystal projector at the
horizontal position.
If you use liquid crystal projector by the lens up
position, the lens down position and the side up
position, this may cause the heat inside to build up and
become the cause of damage.
Be especially careful not to install it with ventilation
holes blocked.
View from the side
A viewing angle of 0û~9û can be changed.
11