Table of Contents
Advertisement
MON192CL10
4.1.3
Extension Cable Installation
Use the Extension Cable (included with the MON192CL10) to place the power supply/base
unit up to 1.5 m (5 ft) from the LCD panel for wall mount or rack mount installations.
1.
2.
Fig. 4.4 Attaching the Power Supply
3.
Fig. 4.5 Connecting the Power Input
4.
5.
Bosch Security Systems, Inc.
Follow the instructions in Section 4.1.2: Wall Mount Installation to remove the power sup-
ply/base from the LCD panel section.
Attach the power supply extension cable by connecting one end of the extension cable
(large connector) to the power supply/base, as shown in Figure 4.4 on page 7.
Connect the other end of the extension cable (small connector) to the power input con-
nector on the rear side of the LCD panel, as shown in Figure 4.5 on page 7.
Connect the appropriate ends of the IEC power cord to the power source (mains) and
power supply/base unit.
Toggle the power switch on the base to the ON position.
Instruction Manual
Installing the MON192CL10 | en
F01U032133 | 1.0 | 2007.03
7
Advertisement
Table of Contents
