Adding Pci Add-On Cards - Supermicro Supero 5015B-MR User Manual

S S
UPER ERVER 5015B-MR User's Manual
System Device
Firmware Hub fl ash memory (System
BIOS)
Local APIC
Area Reserved for the chipset
I/O APIC (4 Kbytes)
PCI Enumeration Area 1
PCI Express (256 MB)
PCI Enumeration Area 2 (if needed)
-Aligned on 256-MB boundary-
VGA Memory
TSEG
Memory available to System BIOS &
OS applications
DD
5-7

Adding PCI Add-On Cards

The SC512-200 chassis uses a riser card to accommodate one add-on card (CSE-
RR1U-EL for a PCI-E
Installing an Add-on Card
1. After powering down the system, remove the PCI slot shield.
2. Fully seat the riser card into the slot, pushing down with your thumbs evenly
on both sides of the card. Seat the expansion card into the riser card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shield protects the serverboard and its components from EMI
and aid in proper ventilation, so make sure it is always in place.
Possible System Memory Allocation & Availability
Size
1 MB
4 KB
2 MB
4 KB
256 MB
256 MB
512 MB
16 MB
1 MB
Figure 5-3. DIMM Installation
To Install: Insert mod-
ule vertically and press
down until it snaps into
place. Pay attention to
the bottom notches.
8 card or CSE-RR1U-X for a PCI-X 3.3V card).
X
5-10
Physical Memory Remaining
(4 GB Total System Memory)
3.99
3.99
3.99
3.99
3.76
3.51
3.01
2.85
2.84
2.84
To Remove: Use your
thumbs to gently push
each release tab out-
ward to free the DIMM
from the slot.