Control Panel Leds; Overheat; Nic2; Nic1 - Supermicro Supero 5015B-MR User Manual

S S
UPER ERVER 5015B-MR User's Manual
3-3

Control Panel LEDs

The control panel located on the front of the SC512-200 chassis has fi ve LEDs.
These LEDs provide you with critical information related to different parts of the
system. This section explains what each LED indicates when illuminated and any
corrective action you may need to take.

Overheat

When this LED is illuminated, it indicates an overheat condition, which may be
caused by cables obstructing the airfl ow in the system or the ambient room tem-
perature being too warm. Check the routing of the cables and make sure all fans
are present and operating normally. You should also check to make sure that the
chassis covers are installed. Finally, verify that the heatsinks are installed prop-
erly (see Chapter 5). This LED will remain on as long as the overheat condition
exists.

NIC2

Indicates network activity on LAN2 when fl ashing

NIC1

Indicates network activity on LAN1 when fl ashing.

HDD

Channel activity for all HDDs. This light indicates DVD-ROM or IDE drive activity
when fl ashing.
3-2