Checking The Drive Bay Setup - Supermicro Supero 5015B-MR User Manual

S S
UPER ERVER 5015B-MR User's Manual
Figure 2-7. Accessing the Inside of the System
4. Make sure all power and data cables are properly connected and not block-
ing the airfl ow. See Chapter 5 for details on cable connections. Also, check
the air seals for damage. The air seals are located under the blower fan and
beneath the frame cross section that separates the drive bay area from the
motherboard area of the chassis.
2-7

Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the Serial ATA drive
have been properly installed and all essential connections have been made.
Checking the Drives
1. For servicing the Serial ATA and DVD-ROM drives, you will need to remove
the top chassis cover. The Serial ATA disk drive is located at the front left side
of the chassis.
2. Refer to Chapter 6 if you need to reinstall a DVD-ROM drive to the system.
3. Depending upon your system's confi guration, your system may have a Serial
ATA hard drive already installed. If you need to install a Serial ATA hard drive,
please refer to the appropriate section in Chapter 6.
2-10