Mounting A New Wheel; Lowering; Tightening Torque - Mercedes-Benz E-Class Coupe Operator's Manual

Mounting a new wheel

G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event
of damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
Always pay attention to the instructions and
safety notes in the "Changing a wheel"
section ( page 367).
Y
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety
reasons, Mercedes-Benz recommends that
you only use wheel bolts which have been
approved for Mercedes-Benz vehicles and the
respective wheel.
! To prevent damage to the paintwork, hold
the wheel securely against the wheel hub
while screwing in the first wheel bolt.
Positioning a wheel (example: vehicle with an
emergency spare wheel)
Changing a wheel
Clean the wheel and wheel hub contact
X
surfaces.
Slide the wheel to be mounted onto the
X
alignment bolt and push it on.
Tighten the wheel bolts until they are
X
finger-tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Tightening the wheel nuts (example: vehicle with
an emergency spare wheel)
Turn the crank of the jack counter-
X
clockwise until the vehicle is once again
standing firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a
X
crosswise pattern in the sequence
indicated (: to A). The specified
tightening torque is 96 lb-ft(130 Nm).
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
X
tools in the trunk again.
371
Z