Floormat; Setting - Mercedes-Benz CLS Operator's Manual

Setting the compass
North America zone map
South America zone map
X
Set your location using the zone maps.
X
Press and hold button =(
approximately three seconds.
The zone currently selected appears in
compass display ;(
X
To select the zone: press
Y
button =( page 294) repeatedly until the
desired zone is selected.
The zone has been selected when compass
display ;( Y page 294) shows the heading.
This takes a few seconds.
Y page 294) for
Y
page 294).
Calibrating the compass
X
Make sure that there is sufficient space for
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the trunk lid.
R
X
Switch on the ignition.
X
Press and hold button =(
approximately six seconds until the
C
symbol appears in compass display ;
( Y page 294).
X
Drive in a full circle at approximately
3 mph (5 km/h) to 6 mph (10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ;(
Floormat on the driver's side
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
Features
Y page 294) for
Y
page 294).
Z
295