Active Multicontour Seat - Mercedes-Benz CLS Operator's Manual

Seats
100
Removing and installing the rear seat
head restraints
G
WARNING
Occupants should only travel sitting on seats
which have the head restraints installed. This
reduces the risk of injury to occupants in the
event of an accident.
! Make sure that the rear window roller
sunblind has been retracted before the rear
head restraints are removed. You could
otherwise damage the roller sunblind.
X
To remove: pull the head restraint up to
the stop.
X
Press release catch : and pull the head
restraint out of the guides.
X
To re-install: insert the head restraint so
that the notches on the bar are on the left
when viewed in the direction of travel.
X
Push the head restraint down until you hear
it engage in position.
Adjusting the multicontour seat
The multicontour seat function is only
available on vehicles for Canada.
To adjust the thigh cushion
:
To adjust the backrest contour in the
;
lumbar region
To adjust the backrest contour in the
=
upper back region
To adjust the side bolsters of the seat
?
backrest
You can adjust the contour of the front seats
individually so as to provide optimum support
for your back and sides.
X
Make sure that the SmartKey is in position
2 in the ignition lock.
Adjusting the active multicontour
seat
Overview
To adjust the seat cushion length
:
To switch the dynamic function on or off
;
To adjust the side bolsters of the seat
=
backrest
To switch the massage function on or off
?