Hazard Warning Lamps; Cornering Light Function; High Beam Flasher - Mercedes-Benz CLS Operator's Manual

Exterior lighting
114
High-beam flasher
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
X
To switch on: turn the SmartKey in the
ignition lock to position 1 or 2 or start the
engine.
X
Pull the combination switch in the direction
of arrow =.

Hazard warning lamps

X
To switch on the hazard warning lamps:
press button :.
All turn signals flash. If you now switch on
a turn signal using the combination switch,
only the turn signal lamp on the
corresponding side of the vehicle will flash.
X
To switch off the hazard warning
lamps: press button :.
The hazard warning lamps automatically
switch on if:
an air bag is deployed.
R
the vehicle is slowed down rapidly from a
R
speed of over 45 mph (70 km/h) and
comes to a halt.
If the vehicle returns to a speed of over
6 mph (10 km/h) after a full application of the
brakes, the hazard warning lamps are
deactivated automatically.
i
The hazard warning lamps still operate if
the ignition is switched off.
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
operated five times ( Y
lights are on and the engine is running. When
you switch off the ignition, the automatic
headlamp cleaning system is reset and
counting is resumed from 0.

Cornering light function

The cornering light function improves the
illumination of the road over a wide angle in
the direction you are turning, enabling better
visibility in tight bends, for example. It can
only be activated when the low-beam
headlamps are switched on.
page 120) while the