Chapter 2 Removal And Replacement Procedure - Fujitsu MHU2100AT Maintenance Manual

CHAPTER 2 Removal and Replacement Procedure

2.1
2.2
This chapter explains the procedure for removing and replacing the disk drive. It
is assumed that the reader has a thorough knowledge of replacing the complete
disk drive and replacing the power-interface cable.
When carrying out these procedures, note the following items.
Be sure to wear a wrist strap when removing the disk drive from the host
system.
The disk drive must have been removed from the host system.
A power-interface cable to the disk drive must be disconnected.
Mounting is done by reversing the steps for removal.
To carry out maintenance properly, observe the following:
Place removed screws and other parts where they will not get lost or
damaged.
Keep a record of all maintenance work.
Tighten screws securely but not excessively.
Before touching the PCA, wear a wrist strap and check it is grounded to
discharge any static electricity from your body. This ensures that the worker
will not electrically damage the PCA.
Do not push the DE cover under any circumstances.
C141-F067-01EN
Spare Parts
Disk Drive Removal
2-1