Table of Contents
Advertisement
Temperature Difference (°C)
(Operating Environment/ Outside)
5
10
15
20
25
30
Table 28: Acclimatization Times for HDD Modules
Always set the HDD module down carefully, with the large surface facing downwards to
l
prevent it from tipping over.
HDD Numbering
For the numbering of the HDD slots see the figure below. Note that this is the numbering
used by the ETERNUS CS800 software, e.g. in Tickets and at the Storage Array Status
page of the Remote Management Console.
Figure 300: 2.5-inch HDD Numbering
16.1.2
HDD Removal and Replacement Procedures
Removing
1. Release the locking mechanism by pressing the locking button (1).
2. Push the handle of the HDD module fully in the direction of the arrow (2).
The HDD module is now unlocked.
3. Wait about 30 seconds to allow the hard disk drive to spin down.
4. Pull the HDD module completely out of its bay (see the figures below).
ETERNUS CS800
16 Removal Replacement Procedures CRUs
Minimum Acclimatization Time (Hours)
3
5
7
8
9
10
471
Advertisement
Table of Contents
