Chapter 2 Removal And Replacement Procedure - Fujitsu MHG2102AT Maintenance Manual

CHAPTER 2 Removal and Replacement Procedure

2.1
2.2
This chapter explains the procedure for removing and replacing the disk drive. It
is assumed that the reader has a thorough knowledge of replacing the complete
disk drive and replacing the power-interface cable.
When carrying out these procedures, note the following items.
•
Be sure to wear a wrist strap when removing the disk drive from the host
system.
•
The disk drive must have been removed from the host system.
•
A power-interface cable to the disk drive must be disconnected.
•
Mounting is done by reversing the steps for removal.
To carry out maintenance properly, observe the following:
•
Place removed screws and other parts where they will not get lost or
damaged.
•
Keep a record of all maintenance work.
•
Tighten screws securely but not excessively.
•
Before touching the PCA, perform the FG (frame ground) to discharge any
static electricity from your body. This ensures that the worker will not
electrically damage the PCA.
•
Do not push the DE cover under any circumstances.
C141-F034-01EN
Spare Parts
Disk Drive Removal
2-1