Table of Contents
Advertisement
AV NETWORK SETUP WIZARD
SETUP PROCEDURE USING AV NETWORK DEVICE CODES:
A DVD Setup example is shown below. Setup of DVD2, VCR, VCR2, PV Recorder, Cable Box and Set-Top-Box follows this
same procedure. If your device is not listed or the device codes not work after following the setup procedure, please refer to the
AV NET Learning wizard procedure on pages 33-34.
1.
Press the A/V Net button on the remote control.
POWER
DVD
DVD2
VCR
VCR2
AV Receiver
Move
Select
SEL
2.
Use CURSOR PADS
or
3.
Press the SELECT button or CURSOR PAD
remote control and the device selection screen appears.
PV Recorder
Cable Box
Set Top Box
Custom
Device Setup
Move
SEL
Select
4.
Use the CURSOR PADS
the SELECT button on the remote control.
5.
The Setup button on the bottom of the screen becomes
highlighted. Press the SELECT button on the remote control
to enter the setup screen.
HITACHI AV NET SET UP
Please choose the device to set up.
( ) DVD
( ) Set Top Box
( ) DVD2
( ) DVD3 (Custom)
( ) VCR
( ) VCR3 (Custom)
( ) VCR2
( ) PVR2 (Custom)
( ) AV Receiver
( ) CBL2 (Custom)
( ) PV Recorder
( ) STB2 (Custom)
( ) Cable Box
List
BACK
SETUP
Move
Select
SEL
6.
Using the remote, enter the four digit Device Code for your
equipment, found on page 25.
7.
Use the CURSOR PAD
CURSOR PADS
or
device is connected.
8.
Repeat step 7 for Audio Input. If the DVD is connected to
the TV, select "Using TV". If the DVD is connected to an external
amplifier, select "no connection".
9.
Press CURSOR PAD
the CURSOR PADS
or
softkeys, before pressing the SELECT button to perform a
Transmission Test of the softkey selected. If the device
responds, then it is properly set up. Select OK. (If the
Transmission Test failed, try another code).
HITACHI AV NET SET UP
DVD
Device Code
- - - -
(Enter Code "9999" to uninstall)
Video Input
No Connection
Audio Input
No Connection
Transmission Test
POWER
BACK
OK
Move
Input
0-9
MENU
HOME
to highlight Device Setup.
on the
or
to choose DVD and press
MODIFY
to select Video Input. Press the
to set the INPUT to which your
to select Transmission Test. Press
to select Power, Play, or CH UP
PLAY
CH UP
EXIT
10. If "OK" was selected, and the 4 digit code was invalid, the
screen below appears, then goes back to the Device
Code
entry screen.
ATTENTION
Find your DVD
4-digit manufacturers code
and enter it here
11. Repeat Device Setup procedure until the screen
below appears.
12. Select CONTINUE to setup another device.
HITACHI AV NET SET UP
Congratulations!
Your DVD is now connected
to your AV network.
Would you like to set up
another device?
Done
Move
Select
SEL
13. Select DONE to finish and the screen below appears to
show the device(s) which has been set-up.
HITACHI AV NET SET UP
Device
Code
DVD
0490
DVD2
----
Not Setup
VCR
----
Not Setup
VCR2
----
Not Setup
AVR
----
Not Setup
PVR
----
Not Setup
CBL
----
Not Setup
STB
----
Not Setup
Custom
----
Not Setup
EXIT
Select
SEL
14. Select EXIT to quit.
23
Continue
Video
Audio
INPUT 2
Using TV
Not Setup
Not Setup
Not Setup
Not Setup
Not Setup
Not Setup
Not Setup
Not Setup
Advertisement
Table of Contents
