Table of Contents
Advertisement
Your Hitachi Plasma Television is equipped with an AV Network feature. This feature helps to control your external Audio/Video
equipment (VCR, Set Top Box, DVD, etc.). Once this is setup, it allows your IR Mouse connector to control your equipment using
your Hitachi Plasma TV Remote Control. You can use your Hitachi remote control to control the Audio/Video equipment command
without the equipment's remote control.
The Plasma Television AVC Center has 2 IR BLASTER jacks. Each IR Mouse cable can connect up to 2 external Audio/Video
components. Therefore, you can connect the Plasma Television with up to four components. Please see the following example of
an AV Network setup between your Hitachi Plasma Television and external Audio/Video equipment (VCR and DVD Player).
CONNECTING EXTERNAL AUDIO/VIDEO COMPONENTS TO IR BLASTER FOR AV NETWORK
1.
Connect your external Audio/Video components to the AVC Center shown on pages 15~21.
2.
Connect the IR Mouse cable to the IR BLASTER output of the AVC Center.
3.
Place the IR mouse in front of the infrared sensor of the external components you wish to control.
4.
Follow the Setup procedure on pages 23-25.
NOTES:
1. The AVC Center has two IR BLASTER outputs which can control up to a total of four external components.
2. The IR Mouse must be placed in front of the external components infrared sensor for the AV Network to work.
3. The correct codes must be entered for each of the Audio/Video components for the AV Network to function properly.
4. Audio/Video component codes for AV network are on page 25.
V
L
R
OUTPUT
Infrared
Infrared
Sensor
Sensor
VCR
IR
Mouse
22
CONNECTING AV NETWORK
OUTPUT
Y
P
/C
P
/C
R
L
B
B
R
R
DVD Player
Advertisement
Table of Contents
