Long Range Wireless Access Point / Client Bridge
4.3.2 IP Settings
Click on the IP Settings link under the System drop‐down menu This page allows
you to configure the device with a static IP address or a DHCP client.
IP Network Setting: Select Obtain an IP address automatically (DHCP) radio
button if the Access Point is connected to a DHCP server. This will allow the
Access Point to pass IP addresses to the clients associated with it. You may select
Specify an IP Address radio button if you would like the device to use a static IP
address. In this case, you would be required to specify an IP address, subnet
mask, and default gateway IP address.
IP Address: Specify an IP address
IP Subnet Mask: Specify the subnet mask for the IP address
Default Gateway: Specify the IP address of the default gateway.
Click on the Apply button to save the changes.
4.3.3 Spanning Tree Settings
Click on the Spanning Tree link under the System drop‐down menu Spanning‐
Tree Protocol is a link management protocol that provides path redundancy
while preventing undesirable loops in the network.
Version 1.0
17