Table of Contents
Advertisement
11.
Attach the computer stand
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
12. Connect your computer and devices to electrical outlets, and turn them on.
13. Right-click the My Computer icon and then click Properties.
14. Click the General tab.
15. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Front-Panel Inserts
CAUTION:
Before you begin any of the procedures in this section, follow the
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
Shut down the
computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
Remove the computer
stand, if it is attached.
5.
Open the computer
cover.
6. Facing the front of the computer, use your fingers to remove the front-panel cover.
7. Press on the inserts until they pop free from the front-panel cover.
(optional).
"Safety
Instructions."
Advertisement
Table of Contents
