Table of Contents
Advertisement
Adding or Removing Cards
CAUTION:
Before you begin any of the procedures in this section, follow the
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
Shut down the
computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
Remove the computer
stand, if it is attached.
5.
Open the computer
cover.
6. Remove the card cage.
a. Check any cables connected to cards through the back-panel openings. Disconnect any cables that will not reach the card cage once it is
removed from the computer.
b. Gently pull on the handle and lift the card cage up and away from the computer.
7. Press the lever on the retention arm and raise the retention arm.
"Safety
Instructions."
Advertisement
Table of Contents
