Table of Contents
Advertisement
CAUTION:
Before you begin any of the procedures in this section, follow the
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
Shut down the
computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
Remove the computer
stand, if it is attached.
NOTICE:
Ensure that there is sufficient space to support the open cover—at least 30 cm (1 ft) of desk top space.
5. Locate the two release buttons shown in the illustration. Then, press the two release buttons as you lift the cover.
NOTICE:
Open the cover slowly to ensure that you do not damage any cables.
Raise the back of the cover, and pivot it toward the front of the computer.
Looking Inside Your Computer
CAUTION:
Before you begin any of the procedures in this section, follow the
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
Be careful when you open the computer cover to ensure that you do not inadvertently disconnect cables from the system board.
"Safety
Instructions."
"Safety
Instructions."
Advertisement
Table of Contents
