Table of Contents
Advertisement
TROUBLESHOOTING
When the resistance setting changes, the motor will be heard. To prevent damage to the motor, do not pull
any of the cables while the resistance setting is changing. If a cable is pulled, the words RELEASE HAN-
DLES AND READJUST RESISTANCE AS DESIRED may appear in the main display on the console.
If this message is displayed repeatedly but no cable is being pulled, there may be too much tension on the
Crossbar Cable (99). Adjust the tension as described below.
ADJUSTING THE CABLE TENSION
13
To decrease the tension on the Crossbar Cable (99),
turn the two 3/8" x 38mm Tension Screws (13) twice,
counterclockwise. Select the desired resistance set-
ting. Repeat this step if necessary.
13
99
21
Advertisement
Table of Contents
