Figure 30: Vap Qos Parameters; Table 39: Vap Qos Parameters - D-Link DWL-8600AP Administrator's Manual

D-Link UAP
Field
Client QoS Global Admin Mode Enable or disable Client QoS operation on the AP.
Radio
VAP
QoS Mode
Bandwidth Limit Down
Bandwidth Limit Up
Page 88 Configuring VAP QoS Parameters

Figure 30: VAP QoS Parameters

Table 39: VAP QoS Parameters

Description
Changing this setting will not affect the WMM settings you configure on the QoS page.
Select Radio 1 or Radio 2 to specify which radio to configure.
Specify the VAP that will have the Client QoS settings that you configure.
The QoS settings you configure for the selected VAP will not affect clients that access the
network through other VAPs.
Enable or disable QoS operation on the VAP selected in the VAP menu.
QoS must be enabled globally (from the Client QoS Global Admin Mode field) and on
the VAP (QoS Mode field) for the Client QoS settings to be applied to wireless clients.
Enter the maximum allowed transmission rate from the AP to the wireless client in bits
per second. The valid range is 0–4294967295 bps.
A non-zero configured value is rounded down to the nearest 64 Kbps value for use in the
AP, but to no less than 64 Kbps. A value of 0 means that the bandwidth maximum limit is
not enforced in this direction.
Enter the maximum allowed client transmission rate to the AP in bits per second. The
valid range is 0–4294967295 bps.
A non-zero configured value is rounded down to the nearest 64 Kbps value for use in the
AP, but to no less than 64 Kbps. A value of 0 means that the bandwidth maximum limit is
not enforced in this direction.
Software User Manual
12/10/09
34CSFP6XXUAP-SWUM100-D13