Configuring Snmpv3 Users; Figure 27: Snmpv3 Users; Table 37: Snmp V3 Users - D-Link DWL-8600AP Administrator's Manual

D-Link UAP
C SNMP
ONFIGURING
From the SNMPv3 Users page, you can define multiple users, associate the desired security level to each user, and
configure security keys.
For authentication, only MD5 type is supported, and for encryption only DES type is supported. There are no default SNMPv3
users on the UAP.
Table 37 describes the fields to configure SNMPv3 users.
Field
Name
Group
Authentication Type
Authentication Key
Encryption Type
Encryption Key
Page 80

Configuring SNMPv3 Users

3 U
V SERS

Figure 27: SNMPv3 Users

Table 37: SNMP v3 Users

Description
Enter the user name to identify the SNMPv3 user.
User names can contain up to 32 alphanumeric characters.
Map the user to a group. The default groups are RWAuth, RWPriv, and RO. You can
define additional groups on the SNMPv3 Groups page.
Select the type of authentication to use on SNMP requests from the user:
• MD5—Require MD5 authentication on SNMPv3 requests from the user.
• None—SNMPv3 requests from this user require no authentication.
If you specify MD5 as the authentication type, enter a password to enable the SNMP
agent to authenticate requests sent by the user.
The passphrase must be between 8 and 32 characters in length.
Select the type of privacy to use on SNMP requests from the user:
• DES—Use DES encryption on SNMPv3 requests from the user.
• None—SNMPv3 requests from this user require no privacy.
If you specify DES as the privacy type, enter a key to use to encrypt the SNMP requests.
The passphrase must be between 8 and 32 characters in length.
Software User Manual
12/10/09
34CSFP6XXUAP-SWUM100-D13