Ups Setup; Checking The Ups Accessory Kit - Eaton Powerware 9140 User Manual

INSTALLATION

UPS Setup

32
Eaton 9140 UPS (7.5–10 kVA) User's Guide
The Eaton 9140 UPS comes with all hardware required for installation in
a standard EIA or JIS seismic rack-mount configuration with square and
round mounting holes. The rail assemblies adjust to mount in 19-inch
panel racks from 24 to 33 inches deep (28.5 to 32 inches deep if
installing the optional seismic mounting brackets).

Checking the UPS Accessory Kit

Verify that the following items are included with the UPS:
S
Mounting brackets and fasteners (if not already installed):
- (4) front mounting brackets
- (2) rear mounting brackets
- (20) M4 flat-head screws, plus (2) extra
S
Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (4) adapter plates (7.1 mm round hole)
- (4) adapter plates (9.5 mm square hole)
- (16) M5 machine screws, plus (2) extra
- (6) M6 machine screws, plus (4) extra
- (6) M6 clip nuts for racks with round holes, plus (4) extra
- (6) M6 cage nuts for racks with square holes, plus (4) extra
- (8) M4 machine screws with (8) M4 locknuts, plus (2) extra of each
S
Cables:
- Serial cable
- USB cable
S
REPO connector
S
Software Suite CD
S
This user's guide
S
Optional seismic mounting brackets and fasteners:
- (2) UPS seismic mounting brackets
- (8) wing bolts, plus (1) extra
- (4) M6 machine screws, plus (2) extra
S 164201622 Rev 3 www.eaton.com/powerquality