Ups Setup; Rack-Mount Setup - Eaton Powerware 9125 User Manual

UPS Setup

The Powerware 9125 UPS is designed for flexible configurations and can
be installed in a rack or as a standalone cabinet.
If you are installing the UPS in a rack, continue to the following section
"Rack-Mount Setup;" otherwise, continue to "Tower Setup" on
page 22.

Rack-Mount Setup

The UPS can be installed in 19- or 23-inch racks and needs only 2U of
valuable rack space.
The UPS and EBM are heavy (see page 53). A minimum of two people are required to lift the
cabinets into the rack.
NOTE Mounting rails are required for each UPS and EBM cabinet. If rails are not already
installed in your rack, contact your local distributor to order rail kits.
To install the UPS and optional EBMs in a rack:
1.
2.
3.
4.
®
EATON Powerware 9125 Two-in-One UPS (700–2000 VA) User's Guide
Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
Attach the supplied mounting handles to the mounting brackets and
secure with the supplied screws (see Figure 5).
Align the mounting brackets with the screw holes on the sides of
the UPS and secure with the supplied screws (see Figure 5).
If installing optional EBMs, repeat Steps 1 through 3 for each
cabinet.
Mounting
Handle
Figure 5. Installing the Mounting Handles and Brackets
S
C A U T I O N
164201514 Rev B www.powerware.com
INSTALLATION
Mounting
Bracket
21