Visit Instruction; Visit Ip Camera From Lan; Set Ip Address - Aztech WIPC408HD User Manual

AZTECH WIPC408HD IP CAMERA USER MANUAL v2.0
3) PC-3 is connected to the Internet.

4.2 Visit Instruction

To visit the IP Camera, you should do some settings of IP Camera and Internet besides
getting the communication link fluency.
1) The PC and IP Camera are in the same LAN. If you want to use this PC to visit the IP
Camera, you need to make sure their IP address is at the same segment. Otherwise you
need to do the reset of the IP Camera's IP address. For example, the IP Camera-1's IP
address in Figure 5 is 192.168.1.139 (at the segment of 192.168.1), while the PC-1's IP
address is 192.168.0.175 (at the segment of 192.168.0), then you will be not able to visit
the IP Camera through the PC-1. You need to change the IP Camera-1's IP address to
192.168.0.139 firstly.
2) The PC and IP Camera are in different LANs, but they are all connected to Internet. For
the IP Camera-1 and PC-2 in Figure 5, if you want to visit IP Camera-1 by PC-2, you
should firstly do the setting as 1) to make sure that you can visit IP Camera-1 through
PC-1 and then do the setting of router-1 (do the port forwarding from the router). The
PC-2's visit application could be sent through router-1 to IP Camera-1. Normally, PC-2
could only send the information to router-1, if you don't do the setting of router-1, then
PC-2 could not visit IP Camera-1.

5 Visit IP Camera from LAN

5.1 Set IP Address

The IP addresses of IP Camera and PC should be at the same segment, in Figure 5, the IP
Camera-1 can't be visited. Run the WIPC408HD Utility in the CD, click Search button, and
then select the IP Camera to reset the IP Camera's IP address, as the Figure 6.
10