The Control Of Pan/Tilt; Notice (For Initial Use); Visit Ip Camera From Wan; Port Forwarding - Aztech WIPC408HD User Manual

AZTECH WIPC408HD IP CAMERA USER MANUAL v2.0
Figure 12
, these buttons are for play, stop, the previous recorder, the next
recorder, open the recorder file. Please click the button of "open the recorder file" first,
and select the file you want to play, you can playback the recorder.

5.2.7 The control of Pan/Tilt

At the control area of Pan/Tilt, the user could control the cruise of the Pan/Tilt by the
arrowhead direction (Up/Down/Left/Right/Centre/Stop/Left-right cruise/Up-down cruise).
When your mouse stops on these control buttons, it will guide you what this button mean.
When the IP Camera turns to some position, you can click the "Set" Button, when you
continue to control the Pan/tilt to turn to other position, you could click the "Call" button, the
Pan/Tilt will go back the pre-position.

5.3 Notice (for Initial Use)

Please change the following settings during initial use:
1) Please refer to the content of part 7.4.1 to change the initial passwords of admin, user,
and guest. Their initial passwords are respectively "admin", "user", "guest".
2) Refer to the content of part 7.5.2 to set the System Time.

6 Visit IP Camera from WAN

6.1 Port Forwarding

Follow the "Visit IP Camera from LAN" steps; make sure PC-1 can visit IP Camera-1. In
Figure 5, before the computers in WAN (PC-2, PC-3) can visit the IP Camera-1, must put the
IP Camera -1 into WAN. You can set Port Forwarding on Router-1 to put IP Camera-1 into
WAN.
15