Interface Of Equipment - Aztech WIPC408HD User Manual

AZTECH WIPC408HD IP CAMERA USER MANUAL v2.0

3.2 Interface of Equipment

1） Power Input Socket: Connect DC adaptor, its output should be 5V power specification.
2） WIFI Antenna Hole: Install the WIFI antenna.
3）
RESET Button: Press the RESET button and hold on more than 10 seconds, the
equipment will restart and recover to the factory default settings. The Pan/Tilt will move
around for one circle and finally focus to the center.
4） RJ45 Ethernet Socket: RJ45 Ethernet socket is 10/100M self-adjust. The equipment
can connect to all kinds of network devices, such as hub, router, switch, etc.
5） Audio Input Socket: Audio input socket is designed for connecting external microphone
or line-in audio signal. Please refer to 7.1.2 and select right settings.
6） Audio Output Socket: Audio output socket is for line-out audio player, such as
headphone, speaker, etc.
7） Alarm Output Socket: The alarm output socket is connected with a relay in the IP
camera. IP camera will control the switch to trigger the alarm bell or buzzer to alarm. The
relay is able to control the switch of a alarm whose voltage is no more than 36V, and
current is lower than 2A. Please refer to the Figure 3 for the connection of an external
alarm.
Output Pins
Switch
8） Alarming Input Pin: Please refer to the schematic Diagram of Figure 4 for how external
detector collects alarm information.
Figure 2
Alarm power
Figure 3
Alarm
8