Table of Contents
Advertisement
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
■ General
Symptom
● The clock is not set to the
● Did a power failure occur? Reset the
correct time.
clock. (Refer to page 14.)
● When
● Set the unit to the power stand-by
a
button
is
pressed, the unit does
mode and then turn it back on.
● If the unit still malfunctions, reset it.
not respond.
(Refer to page 41.)
● No sound is heard.
● Is the volume level set to "0"?
● Are the headphones connected?
● Are the speaker wires disconnected?
■ Video CD
Symptom
● The picture is not dis-
● Is the TV unplugged?
● Is the unit connected improperly?
played during playback.
● Is the input selector on the TV set to
other than "VCR"?
● Is the unit being played without se-
lecting video CD?
● The picture quality is
● Is the disc very dirty?
poor or it is distorted.
■ CD player
Symptom
● Playback does not start.
● Is the disc loaded upside down?
● Playback stops in the
● Does the disc satisfy the standards?
● Is the disc distorted or scratched?
middle or is not per-
formed properly.
● Playback sounds are
● Is the unit located near excessive vi-
skipped, or stopped in
brations?
● Is the disc very dirty?
the middle of a track.
● Has condensation formed inside the
unit?
■ Tuner
● The radio makes unusual
noises continuously.
Possible cause
■ Remote control
● The remote control does
not operate.
Possible cause
■ Cassette deck
● Cannot record.
● Cannot record tracks with
proper sound quality.
● Cannot erase completely.
● Sound skipping.
Possible cause
● Cannot hear treble.
● Sound fluctuation.
● Cannot remove the tape.
Symptom
Possible cause
● Is the unit placed near the TV or
computer?
● Is the FM aerial or AM loop aerial
placed properly? Move the aerial
away from the AC power lead if it's
located nearby.
Symptom
Possible cause
● Is the AC power lead of the unit
plugged in?
● Is the battery polarity correct?
● Are the batteries dead?
● Is the distance or angle incorrect?
● Does the remote control sensor
receive strong light?
Symptom
Possible cause
● Is
the
erase-prevention
removed?
● Is it a normal tape? (You cannot
record on a metal or CrO tape.)
● Is there any slack?
● Is the tape stretched?
● Are the capstans, pinch rollers, or
heads dirty?
● If a power failure occurs during
playback,
the
engaged with the tape. Do not open
the compartment with great force.
04/1/28
CX-GD5200V_EN2.fm
GX-CD5200V
ENGLISH
tab
heads
remain
E-40
Advertisement
Table of Contents
