Listening To The Radio - Sharp GX-CD5200V Operation Manual

■ To change the audio mode
Sound of the playback source can be switched among the STEREO,
L-CH, R-CH, and V-CANCEL (VOCAL CANCEL) modes.
The audio mode function is used when the left and right channels
have individual signals from each other.
Press the VCD AUTO/VCD/AUDIO
MODE button on the remote
control until the desired audio
mode is displayed.
Each time the VCD AUTO/VCD/
AUDIO MODE button is pressed,
the mode will change as follows:
STEREO L-CH R-CH
STEREO Sounds on the left and right channels are played.
L-CH Sounds on the left channel only are played.
R-CH Sounds on the right channel only are played.
V-CANCEL The main vocal is lowered.
Notes:
● The initial audio mode setting is "STEREO".
● When playing a sound multiplexed disc on which a vocal and
music have been separately recorded, select the audio mode as
desired.

Listening to the radio

■ Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
V-CANCEL
desired frequency band (FM, SW-1, SW-2 or MW).
3
Press the TUNING (
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will stop
at the first receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may stop
automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING button again.
04/1/28
or ) button to tune in to the desired
CX-GD5200V_EN2.fm
GX-CD5200V
ENGLISH
E-28