Loading The Tool - Central Pneumatic 69575 Owner's Manual & Safety Instructions

Loading the Tool

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Pull the Pusher down until it locks into
place at the back of the Magazine.
2. Insert the fasteners into the top of the
Magazine. NOTE: Load fasteners with
the pointed ends facing downward.
3. Hold the Pusher in place while pressing the Pusher
Latch, unlocking the Pusher. WARNING! The
Pusher is spring-loaded and will forcefully move
forward when released. Once the Pusher Latch is
pressed, make sure to hold the Pusher in place,
and then guide it up the back of the Magazine.
General Operating Instructions
1. Before each use, test the tool as
directed in the prior section.
2. If an automatic oiler is not used, add a few
drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
WARNING! TO PREVENT
SERIOUS INJURY: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in an
unexpected direction.
CAUTION! TO PREVENT INJURY: Do not hold tool
near body while firing. Tool recoil can cause injury.
3. Position tool at desired fastener location and depress
the Safety Nosepiece fully against the workpiece.
Squeeze the trigger to fire a fastener.
4. Adjust the Depth Adjustment Knob
to control the firing depth.
Item 69575 For technical questions, please call 1-800-444-3353.
16 Gauge
Nail Strip
FIG . 6
Figure C: Nail Loading Detail
5. If, at the maximum depth setting, the tool requires
more force to accomplish the task, verify that the tool
receives sufficient, unobstructed airflow (CFM) and
increase the pressure (PSI) output of the regulator
up to the maximum air pressure rating of this tool.
CAUTION! TO PREVENT INJURY FROM TOOL OR
ACCESSORY FAILURE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
6. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the trigger again.
e. Clean external surfaces with clean, dry cloth.
f. Store indoors out of children's reach.
Pusher
Latch
Pusher
Magazine
Page 13