Table of Contents
Advertisement
Connecting the AM Aerial
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are
marked AM ANT.
To avoid noise interference, check that the loudspeaker wires do not run
close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
MIC Function (option)
Preparation
Plug the microphone with a 3.5mm phono jack into
microphone terminal.
CD
isplay
EPEAT
Power Sound
Repeat(A<->B)
CD Synchro
Connecting the FM Aerial
There are two types of aerial, (depending on option chosen).
1
How to connect a COAXIAL TYPE aerial.
Connect a 75 antenna to the FM aerial terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75 ) marked FM on the rear of the system.
Follow the instructions given on Page 8 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear
of the system, using a 75 coaxial cable (not supplied).
2
How to connect a SCREW TYPE wire aerial.
The FM aerial connector terminals are located on the rear of the
system and marked FM(75 ).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
Connecting the SW Aerial (option)
1
How to connect a WIRE TYPE wire aerial.
Spread the SW aerial out and attach the ends to a wall,
in the position providing the best reception.
If reception is poor (e.g. distance from transmitter too great,
walls blocking the radio waves, etc.), install an outdoor aerial.
CD DIGITAL OUT
GB
FM
FM
75 COAXIAL CABLE
FM AERIAL
(not supplied)
(supplied)
ANTENNA
AM
SW ANT
5
Advertisement
Table of Contents
