Connecting The Loudspeakers; Connecting The Am (Mw/Lw) Aerial; Connecting The Fm Aerial; Connecting The Sw Aerial (Option) - Samsung MAX-VJ550 Instruction Manual

Connecting the Loudspeakers

The loudspeaker connector terminals are located on the rear
GB
of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the – terminals
1
Press and hold the terminal tab.
2
Insert the speaker cord.
3
Release the finger.
L
R
8
Connecting the AM (MW)/LW Aerial
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system
and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not
run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.
Connect a 75 antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket
(75 ) marked FM on the rear of the system.
Follow the instructions given on Page 18 to tune into a radio sta-
tion, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear
of the system using a 75 coaxial cable (not supplied).

Connecting the SW Aerial (option)

How to connect a WIRE TYPE aerial.
Spread the SW aerial out and attach the ends to a wall, in the position
providing the best reception.
If reception is poor (e.g. distance from transmitter too great, walls blocking
the radio waves, etc.), install an outdoor aerial.

Connecting to the Equipment

Using the Audio Cord, Connect the Audio Output Terminals (Left, Right)
of the System with the Audio Input Terminals (Left, Right) of the Video
Input Cassette Recorder, so as to Record VCD.
Using the Video Cord, Connect the Video Output Terminal of the system
with the Video Input Terminal of TV.
Turn on the TV and Select the Video mode by pressing the TV/VIDEO
SELECT button to the VIDEO Position.
Please Pay Attention not to Connect the Audio Output Terminals (left,
right) of the System with the Audio Input Terminal of TV.
AMPLIFIER
TV
AUDIO INPUT
VIDEO INPUT
R L

DEMO/DIMMER function

All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
1
Press the DEMO/DIMMER button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
2
Press the DEMO/DIMMER button again.
Result: The Dimmer function is selected and the display darkens.
3
Press the DEMO/DIMMER button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.
GB
9